Motorola iDEN Site Controller System Manual page 22

Chapter 1 Manual Overview
Static Sensitive Precautions
1-8
Be sure to ground all electrically powered test equipment. Connect a
I
ground lead (-) from the test equipment to the board or module before
connecting the test probe (+). When testing is complete, remove the test
probe first, then remove the ground lead.
Place all circuit boards and modules on a conductive surface (such as a
I
sheet of aluminum foil) when removed from the system. The conductive
surface must be connected to ground through 100kΩ.
Never use non-conductive material for packaging modules for shipment or
I
storage. All modules should be wrapped with anti-static (conductive)
material. Replacement modules shipped from the factory are packaged in a
conductive material.
If possible, retain all original packing material for future use.
I
Gen 3 Site Controller System Manual
68P80801E30-A 5/1/2002