Standby Site Controller Status - Motorola iDEN Site Controller System Manual

Chapter 6 System Testing

Standby Site Controller Status

Standby Site Controller
Status
6-14
To check the status of the standby Controller, use the following procedure.
At the iSC> prompt, type: ping standby
Verify the following message on the service computer:
iSC> ping standby
Standby iSC is
Standby GPS is
The standby GPS always has a response of NOT AVAILABLE. This
Note:
is a normal indication and does not indicate a failure.
If the standby site controller is powered off, or if there is a communication
problem, then a time-out occurs and the following is displayed:
iSC> ping standby
Ping standby isc is not successful.
Gen 3 Site Controller System Manual
available
not available
68P80801E30-A 5/1/2002