Siemens MOBILETT Plus HP Service Instructions Manual page 116

11 - 4
1
Fig. 6
•
With the wrench, adjust the tension of the transmission belt equally on the two tension
bearings to a minimum distance of 1-1.5 mm between the bearing and the washer
(Fig. 4). The tension of the transmission belt is right when the adjustment device and the
belt are in contact in exactly three points (1/Fig. 6).
In (2/Fig. 6) the belt is too tight and in (3/Fig. 6) the belt is too slack.
•
Tighten the screws (A/Fig. 4).
•
Remount the wheel.
•
Fit the covers.
MOBILETT Plus HP
2 3
SPR8-220.061.03
Rev. 03 09.03
Motor drive units
Page 4 of 8
CS PS 24 Medical Solutions
Siemens AG