Repairs To The Motor Power Unit; Exchange Of Motor Power Unit D102 - Siemens MOBILETT Plus HP Service Instructions Manual

11 - 6
1
Fig. 9
•
To prevent the other wheel from turning, secure it with several wedges.
Do not apply the parking brake.
•
Remove the wheel, four screws as shown in (Fig. 8).
•
Remove the six screws that hold the motor. Two of the screws can be accessed through
a hole in the toothed wheel.
•
Remove the complete motor unit inward through the opening in the chassis.
•
Install the new motor with the six screws.
•
Install the motor power unit (D102) or battery charger (D201). Refer to (Fig. 7) for
electrical connections.
•
Install the wheel with the four screws.
•
Remove the block of wood.
•
Reattach the covers.

Repairs to the motor power unit

The motor power unit should not be repaired. If the motor power unit is defective (with the
exception of 4 A fuse), the entire unit should be replaced.

Exchange of motor power unit D102

•
Remove the front cover.
•
Disconnect K101, 102, 104, 106 on D102.
•
Remove the two front screws (1/Fig. 9).
MOBILETT Plus HP
1
SPR8-220.061.03
Rev. 03
Motor drive units
Page 6 of 8
09.03 CS PS 24
11
11
Siemens AG
Medical Solutions