Adjustment Of The Hand/Parking Brake - Siemens MOBILETT Plus HP Service Instructions Manual

Mechanical systems
Fig. 22

Adjustment of the hand/parking brake

DANGER
Equipment required: Spring scale
•
Disconnect the unit from the wall outlet.
•
Block up the unit on both sides with 5 x 5 cm pieces of wood. The wheels must be able to
rotate independently.
•
Remove the rear wheel by removing the screw.
•
Check the brake linings. If the brake linings are thinner than 1 mm, they must be replaced
(Fig. 22).
•
Remove the old lining by loosening the screw (pos. 1 / Fig. 22).
•
When installing the new lining, make sure that the lining is facing the right way.
•
If the braking linings meet the requirements and the braking force is still low, check the
tension of the brake wire.
•
Remount the rear wheels.
Siemens AG
Medical Solutions
Braking
wire
High Voltage!
Life-threatening hazard of electric shock. Never work with the
system open if the batteries are still connected and the capacitor
is charged. If the batteries are connected, the complete system is
powered on!
The capacitors in M10 and M11 may still be charged even if the
system is switched OFF and the mains cable is
disconnected. The capacitors in M10 and M11 must be consid-
ered charged until the protective measures listed in this section
have been performed.
SPR8-220.061.03
Rev. 03 09.03
MOB00657
Page 21 of 28
CS PS 24
10 - 21
1
> 1 mm
10
MOBILETT Plus HP