Brake Force / Brake Torque; Measuring The Horizontal Force Required For Movement - Siemens SIREMOBIL Iso-C Troubleshooting Manual

Brakes / Movements
7-

Brake force / brake torque

7Brakes / Movements
Fig. 52:
Pos. 1 Attachment points - spring scale
Pos. 2 Attachment points - spring scale
WARNING

Measuring the horizontal force required for movement

The attachment point for the spring scale is the end of the railing near the image intensifier
in sector B and/or the handgrip of the horizontal carriage. The carriage must always be
pulled at a constant speed.
The maximum force for moving the horizontal carriage consistently when the
brakes are released is 80 N.
When the brakes are applied, the force must be 180 N.
Measurement A-C: At the handgrip of the horizontal unit, the measuring
Measurement C-A: At the railing near the image intensifier, the measur-
© Siemens, 2008
For internal use only
Risk of injury on mechanical parts!
If these guidelines are not followed, minor to moderate injury,
especially to the hands, can occur.
Follow the notes concerning the C-arm carbon fiber
structure.
points move to 30, 170 and 200 mm
ing points move to 30, 170, and 200 mm
SPR2-230.840.01.01.02
08.08
Page 135 of 148
CS PS SP
135
0
0
SIREMOBIL Iso-C