Siemens SIREMOBIL Iso-C Troubleshooting Manual page 75

Adjustments / Programs
Function:
Display of rotated images
Product name
Diagnostics
Create External Disk (1)
Enable Bridge (1)
Delay 3D-PC/ DICOM Bridge
(1)
Interface to 3D-PC
Monitor zoom
Monitor split
Monitor text
Maximum no. of images
Default programs changeable Default: Yes. The organ programs can be protected against
Default LUT
Default LUT for Subtraction
Default Edge
Software compatibility
© Siemens, 2008
For internal use only
Comments:
Yes: When pressing the image rotation key, the current
image will be computerized and displayed. NO: The rotated
image will not be computerized when pressing the image
rotation key. For SIREMOBIL Iso-C always set to YES.
Allows you to change the MEMOSKOP name displayed dur-
ing system booting. Enter SIREMOBIL Iso-C.
Allows you to call test routines for repair by the manufacturer
of the MEMOSKOP. The MEMOSKOP can be reset via
"Load factory default", as required. Subsequently, you have
to program accordingly. The same applies if you replace the
MEMOSKOP
MEMOSKOP CE and MEMOSKOP CE-100: Program the
value to "No". All other types of MEMOSKOP: If a MOD drive
is implemented and/or the option "3D Reconstruction" is
installed and/ or the option DICOM Bridge is installed, pro-
gram the value to "Yes".
MEMOSKOP CE and MEMOSKOP CE-100: Program the
value to "No". All other types of MEMOSKOP: If a MOD drive
is implemented and/or the option "3D Reconstruction" is
installed and/ or the option DICOM Bridge is installed, pro-
gram the value to "Yes".
Only available if option "3D Reconstruction" is installed.
Configure 120.
Only available if option "3D Reconstruction" is installed.
Configure Yes.
Yes: When pressing the key for MEMOSKOP - Zoom, the
image will be displayed enlarged. NO: The MEMOSKOP -
Zoom key has no function. For MEMOSKOP C-E set to NO.
Otherwise set to YES.
Yes: Horizontal or vertical image split possible. No: No hori-
zontal or vertical image split possible. Program Yes.
Yes: Superimposes text. No: No text superimposition. For
SIREMOBIL Iso-C always set to Yes.
The number of stored images can be programmed. Program
the value to 700 for MEMOSKOP C and to 900 for
MEMOSKOP SUB. For MEMOSKOP C-E 100 program the
value to 100. For MEMOSKOP C-E, this parameter is not
used.
changes by setting "No".
After switch-on, the programmed brightness/contrast curve
(LUT) is selected automatically: Default: LUT 2
After switch-on, the programmed brightness/contrast survey
(LUT) is selected automatically for the subtraction mode,
when equipped with a MEMOSKOP C-Sub. Default: LUT 1
After switch-on, the programmed edge enhancement is
selected automatically: For MEMOSKOP SUB, set to 1.
Not implemented. Must be set to "No".
SPR2-230.840.01.01.02
08.08
Page 75 of 148
CS PS SP
75
SIREMOBIL Iso-C