Siemens SIREMOBIL Iso-C Troubleshooting Manual page 116

116
Roadmap K-Factor, phase B Program "MD 2". Program a different value only upon cus-
Roadmap K-Factor, phase C Program "MD 2". Program a different value only upon cus-
Roadmap Time of phase A
Configure the following parameters in User Setup for MEMOSKOP:
Operating mode Parameters Change the programmed parameters only upon customer
VCR output
Hardcopy Release
Text monitor
Split screen
Display of time
Set Date / Time
Hospital Name
Storage of Dose on disk
Dose on Hardcopy output
Perform the IQ quick test.
NOTE
SIREMOBIL Iso-C
Replacing boards and components
tomer request.
tomer request.
Program "4.5". Program a different value only upon cus-
tomer request.
request.
Configure to monitor A.
For SIREMOBIL with 1 monitor: Configure to monitor A.
For SIREMOBIL with 2 monitors: Configure to monitor B.
For SIREMOBIL with 1 monitor: Configure to monitor A.
For SIREMOBIL with 2 monitors: configure to both moni-
tors.
Configure horizontally. Configure vertically only upon cus-
tomer request.
Configure Yes.
Set the current date and time.
Enter the hospital name.
If dose-area product measurement device is present (Dia-
mentor), configure Yes. Otherwise configure No.
If dose-area product measurement device is present (Dia-
mentor), configure Yes. Otherwise configure No.
With present MODULARIS system, the parameters for the
Litho program have to be set again according to the LITHOS-
TAR MODULARIS Service Instructions.
SPR2-230.840.01.01.02
08.08
Page 116 of 148
CS PS SP
© Siemens, 2008
For internal use only