Required Tools, Measurement And Auxiliary Devices - Siemens SIREMOBIL Iso-C Troubleshooting Manual

8

Required tools, measurement and auxiliary devices

NOTE
DMM
Oscilloscope > 50 MHz
Dose meter
Safety tester
Service PC *
Service software (refer to SIREMOBIL Iso-C logbook) *
Connection cable, Service-PC - SIREMOBIL Iso-C
1 set of resolution tests
1 set of radiation filters
Center cross
Heat conducting paste WPS
Special purpose oil (Optimol Optipit)
Special purpose oil (Slic Pac PTFE)
Sealing compound
Standard tool kit*
1 set of Allen keys*
200 N spring scale
Torque wrench, 20 Nm to 100 Nm
Torque wrench, 3 Nm to 20 Nm
A 30 mm socket key (required for adjusting the brake) *
For SIREMOBIL Iso-C 3D, in addition
Iso-C 3D calibration phantom
Luminance meter
SIREMOBIL Iso-C
All tools and measurement and auxiliary devices with the
exception of those marked "*" are listed along with their
specifications in the SPC (Spare Parts Catalog).
e.g. Fluke 287
e.g. Fluke ScopeMeter 199 CM
e.g. PTW-DIADOS
e.g. BENDER Unimet 1100
e.g. SMfit Spotmeter
SPR2-230.840.01.01.02
08.08
Page 8 of 148
CS PS SP
Prerequisites
1.1
99 94 831
73 92 074
97 17 612
51 38 727
e.g. 99 00 440
e.g. 28 71 820
e.g. 97 98 596
e.g. 96 60 051
e.g. 20 48 650
55 07 525
55 07 517
20 49 716
e.g. 44 15 113
e.g. 44 30 906
e.g. 70 59 975
75 51 620
77 52 848
© Siemens, 2008
For internal use only