Siemens SIREMOBIL Iso-C Troubleshooting Manual page 90

90
Fig. 29:
Remove the cover on the front side of the C-arm by removing the screws (I.I. side, refer
to (Fig. 29 / p.
Move the I.I. into the service position. See
Remove both attachment screws for the control section in the I.I. flange of the C-arm
(arrow/(Fig. 30 / p.
Carefully remove the control section from the C-arm and disconnect all the plugs.
Disconnect the protective conductor.
Remove the VIDEOMED DC camera from the I.I.
See Replacing boards / Replacing components VIDEOMED DC.
Fig. 31:
Remove both attachment screws for the high voltage section from the I.I. flange of the
C-arm ((Fig. 31 / p.
Remove the high voltage section from the C-arm.
SIREMOBIL Iso-C
Replacing boards and components
90)).
90)).
90)).
SPR2-230.840.01.01.02
08.08
Fig. 30:
(I.I. service position / p.
Page 90 of 148
CS PS SP
25).
© Siemens, 2008
For internal use only