Special Tools - Yamaha XVS250 2001 Service Manual

EB102001

SPECIAL TOOLS

The following special tools are necessary for complete and accurate tune-up and assembly. Use only
the appropriate special tools; this will help prevent damage caused by the use of inappropriate tools or
improvised techniques. Special tools may differ by shape and part number from country to country. In
such a case, two types are provided.
When placing an order, refer to the list provided below to avoid any mistakes.
Tool No.
Bolt Slide hammer bolt/Weight
90890-01085
Weight These tools are used to remove the rocker
90890-01084 arm shaft.
Valve adjusting Tappet adjusting tool
tool
This tool is used to adjust the valve
90890-01311 CLEARANCE.
T-handle T-handle/Damper rod holder (22 mm)
90890-01326
Damper rod
holder These tools are needed to loosen and
90890-01365 tighten the damper rod holding bolt.
Piston pin puller set
90890-01304
This tool is used to remove the piston pin.
Fuel level gauge
90890-01312
This gauge is used to measure the fuel level in
the float chamber.
Flywheel puller
Flywheel puller
90890-01362
These tools are needed to remove the rotor.
Ring nut wrench
90890-01403
This tool is used to loosen and tighten the
steering stem ring nut.
Weight Front fork seal driver weight/
90890-01367 Adapter (33 mm)
Adapter These tools are needed when installing the
90890-01369 slide metal, oil seal and dust seal into the fork.
Tool name / How to use
1-5
SPECIAL TOOLS
GEN
INFO
Illustration