Table of Contents
Advertisement
CHECKING AND ADJUSTING THE STEERING HEAD
LUBRICATING THE DRIVE CHAIN/
EAS00142
LUBRICATING THE DRIVE CHAIN
The drive chain consists of many interacting
parts. If the drive chain is not maintained proper-
ly, it will wear out rapidly. Therefore, the drive
chain should be serviced, especially when the
motorcycle is used in dusty areas.
This motorcycle has a drive chain with small
rubber O-rings between each side plate. Steam
cleaning, high-pressure washing, certain sol-
vents, and the use of a coarse brush can dam-
age these O-rings. Therefore, use only kerosine
to clean the drive chain. Wipe the drive chain dry
and thoroughly lubricate it with engine oil or
chain lubricant that is suitable for O-ring chains.
Do not use any other lubricants on the drive
chain since they may contain solvents that
could damage the O-rings.
EAS00146
CHECKING AND ADJUSTING THE STEER-
ING HEAD
1. Stand the motorcycle on a level surface.
Securely support the motorcycle so that
there is no danger of it falling over.
NOTE:
Place the motorcycle on a suitable stand so that
the front wheel is elevated.
2. Check:
3-32
Recommended lubricant
Engine oil or chain lubricant
suitable for O-ring chains
WARNING
D steering head
Grasp the bottom of the front fork legs and
gently rock the front fork.
Looseness or binding Adjust the steering
head.
CHK
ADJ
Advertisement
Table of Contents
Troubleshooting
