Original installation and operation manual
Wrong
6.3 Assembly work
For assembly work to be carried out, the following prerequisites must be fulfilled and the preparatory tasks must have
been completed.
Tools
•
Spanner or adjustable end wrench
Depressurise the pressurised system or the respective system section and secure it against unintentional
1.
pressurisation.
2.
Get the hose and hose clamp ready for connection to the condensate discharge.
Right
Prerequisites
Material
•
Sealants e.g. PTFE
•
Feed line
•
Drain line
•
Hose, interior diameter
8 ... 10 mm (0.31 ... 0.39 in),
length approx. 30 cm (1 ft)
•
Hose clamp
Preparatory tasks
Description / explanation
Ensure venting
•
If the slope in the inflow is not sufficient or
there are other problems with the inflow,
install a venting line.
Discharge from pressurised pipes
•
Divert the flow of gas to provide a deflecting
surface to discharge the fluid components in
the gas.
Protective equipment
Always to be worn:
BEKOMAT
16i CO
®
33 | 76