11.4.1 Built-In Positioning Parameter Setting - Mitsubishi Electric FX3S Series User Manual

FX /FX /FX
3S 3G 3GC
Built-in Positioning Functions
11.4 Built-in Positioning Parameter Setting
Use GX Works2 or GX Developer to set the built-in positioning parameters.
The "Pulse" and "Frequency" set by the built-in positioning parameters in a positioning table can be changed
using the program, display module, or HMI.

11.4.1 Built-in Positioning Parameter Setting

Assuming that GX Works2 is used, this section describes how to set the built-in positioning parameters.
1
Open the "Parameter Setting" screen.
On the project view of the navigation window displayed, double-click "Parameter" and then "PLC
Parameter".
If the navigation window is not displayed, click "View" on the menu bar, and then click "Docking
Window", and then click "Navigation".
B - 154
Downloaded from ManualsNet.com
/FX /FX PLC User's Manual - Positioning Control Edition
3U 3UC
To change the set "number of pulses" or "frequency", refer to Subsection 11.4.2.
For details on GX Developer operating procedure, refer to GX Developer Operating Manual.
search engine
11 Batch Data Positioning Mode - TBL Instruction
11.4 Built-in Positioning Parameter Setting