Mitsubishi Electric FX3S Series User Manual page 181

FX /FX /FX
3S 3G 3GC
Built-in Positioning Functions
The rotation direction ON/OFF status of the specified device is shown in the following table.
During instruction execution, however, do not use the output
ON/OFF status of device
5) The interrupt input signal depends on the pulse output of
Use an FX
Use an FX
Pulse output
*1.
Designation of interrupt input using M8336 interrupt input specification function:
1) Turn on the M8336.
2) Set the interrupt input number (X000 to X007) in D8336, or specify the user interrupt input command
D8336=H
Downloaded from ManualsNet.com
/FX /FX PLC User's Manual - Positioning Control Edition
3U 3UC
D
specified by
2
If the number of pulses to be output after interruption (specified by
ON positive number, the operation will be performed in the forward rotation direction.
Forward rotation (Outputting pulses from
If the number of pulses to be output after interruption (specified by
OFF negative number, the operation will be performed in the reverse rotation direction.
Reverse rotation (Outputting pulses from
PLC Ver. 1.30 or later to use the interrupt input specification function.
3UC
/FX PLC Ver. 2.20 or later to set the user interrupt input command.
3U 3UC
If it is not necessary to use the
destination
interrupt input specification
device
function (M8336 = OFF), or if the
FX PLC below Ver. 1.30 is used
3UC
D = Y000
1
D = Y001
1
= Y002
D
1
*1
= Y003
D
1
Y003 is available only when two high-speed output special adapters are connected to the FX
For details on the specification method, refer to Subsection 4.3.7 or Subsection 4.5.1.
Interrupt input for Y000
(pulse output destination device)
Interrupt input for Y001
(pulse output destination device)
Interrupt input for Y002
(pulse output destination device)
Interrupt input for Y003
(pulse output destination device)
Setting value
0 Specifies X000 for the interrupt input signal.
1 Specifies X001 for the interrupt input signal.
7 Specifies X007 for the interrupt input signal.
search engine
9 One-speed Interrupt constant quantity feed - DVIT Instruction
Rotation direction (increase/decrease current value)
Interrupt input signal
If it is necessary to use the interrupt input
D8336=H
X000
X001
X002
X003
Description of setting
9.3 Function and Operation
for other purposes.
D
2
S
1
D
will increase the current value.)
1
S
1
D
will decrease the current value.)
1
as shown in the following table.
D
1
specification function
(M8336 = ON)
Interrupt input for Y000
(pulse output destination device)
Interrupt input for Y001
(pulse output destination device)
Interrupt input for Y002
(pulse output destination device)
Interrupt input for Y003
(pulse output destination device)
A
B
) is set to a
) is set to a
Apx.
PLC.
3U
*2
.
B - 137