Mitsubishi Electric FX3S Series User Manual page 192

FX /FX /FX
3S 3G 3GC
Built-in Positioning Functions
3) For
When a high-speed output special adapter is used as a destination for pulse output on a FX
the output shown in the following table for rotation direction signals.
When a built-in transistor output is used as a destination for pulse output on a FX
FX
1st adapter
2nd adapter
The rotation direction ON/OFF status of the specified device is shown in the following table.
During execution of this instruction, however, do not use the output
ON/OFF status of device
B - 148
Downloaded from ManualsNet.com
/FX /FX PLC User's Manual - Positioning Control Edition
3U 3UC
, specify the rotation direction signal output device number.
D
2
PLC, use transistor output for signals rotation direction.
3UC
High-speed output special
adapter number
specified by D
2
If the number of output pulses specified by
ON operation will be performed in the forward rotation direction.
Forward rotation (Outputting pulses from
If the number of output pulses specified by
OFF operation will be performed in the reverse rotation direction.
Reverse rotation (Outputting pulses from
search engine
10 Variable Speed Operation (Variable Speed Pulse Output) - PLSV Instruction
Pulse output Rotation direction
destination device
= Y000
D D
1
= Y001
D D
1
= Y002
D D
1
= Y003
D D
1
Rotation direction (increase/decrease current value)
10.3 Function and Operation
/FX /FX
3S 3G
output
Y004
=
2
Y005
=
2
Y006
=
2
Y007
=
2
for other purposes.
D
2
S is a positive number, the
will increase the current value.)
D
1
is a negative number, the
S
will decrease the current value.)
D
1
PLC, use
3U
/FX /
3GC 3U