Mitsubishi Electric FX3S Series User Manual page 199

FX /FX /FX
3S 3G 3GC
Built-in Positioning Functions
2
Set the memory capacity.
Click on the «Memory Capacity» tab, and then click on the "Positioning Instruction Settings" check
box to enter check the box.
9,000 steps are needed to set the built-in positioning data. If there is not enough capacity for
programming, set the "Memory capacity" to 16,000 steps or more.
Memory Capacity
Comment Capacity
File Register Capacity
Program Capacity
Special Function Memory
Capacity
Special Function Block
Settings
Positioning Instruction
Settings
Built-in CC-Link/LT
Settings
*1.
*2.
*3.
Downloaded from ManualsNet.com
/FX /FX PLC User's Manual - Positioning Control Edition
3U 3UC
*1
Check the box.
Setting item
Set the capacity of the program memory. Initial value: 16000
Set the capacity for the comments to be stored in the PLC. Initial
value: 0
Device comment: 50 points/block (500 steps)
Set the capacity for the file registers. Initial value: 0
File registers: 500 points/block (500 steps)
Displays the number of steps that can be used for the sequence
program.
Set whether "Special Function Block Settings",
"Positioning Instruction Settings", "Built-in CC-Link/LT Settings"
should be enabled.
Check the box to enable the special function unit/block initial data
setting function. Use the «Special Function Block» tab to set the
*2
initial value of a special block.
Check the box to enable the TBL (FNC152) instruction setting
function. Use the «Positioning» tab to set the built-in positioning
data.
Check the box to enable the built-in CC-Link/LT setting function. Use
*3
the «Special Function Block» tab to set the built-in CC-Link/LT data.
The initial value is 8000 steps in the
Only available for and
FX
3U
Only available for FX -32MT-LT-2 PLC.
3UC
search engine
Description of setting
/ PLC.
FX FX
3G 3GC
PLCs.
FX
3UC
11 Batch Data Positioning Mode - TBL Instruction
11.4 Built-in Positioning Parameter Setting
*1
A
B
Apx.
Setting range
Refer to the
programming
manual.
-
-
-
-
B - 155