Mitsubishi Electric KD Series User Manual page 50

3-3 Connections
3-3-4 DC24V Connectors
* These connectors are available
only for the product with illumination .
V2
item
Power supply for
illumination （ +24V)
Internal circuit
(for reference)
1
6
No7 Pin
7
To LED driver
circuits
TM-XG537C
Product type
No.
A3 A1 A0
V2
○ ○ ○
V3
× ○ ○
To other system
circuits
COPYRIGHT © 2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
Be sure to check connection interface (connector joint, wire diameter)
【 DC24V Cable connection (for illumination) 】
*Cable is not in product package. Prepare it by yourself.
1) V2,V3 connectors are connected with 24V power supply .
2) CIS is equipped with
DEU-9S-F0R （ by JAE) as connectors,
030-50634 （ by JAE) as contact socket.
3) Connector for Power Cable (strongly recommend using)
DEU-9P-F0R （ by JAE ） as contact socket housing,
030-50635 （ by JAE) as contact pin.
4) Turning On/Off control for illumination can be done by
the signal "LED_CONT" assigned to 7-pin of connector .
5) Connect 7-pin of connector to GND signal
directly , if it is not necessary to use the external control
of illumination.
6) 24V power supply have to be turned On/Off during 5V
power supply turned On . Refer on chapter 4 .
7) Pin assignment table is following .
KD-MX series
No
Name I/O
1
+24V
I
2
ＮＣ -
3
ＮＣ -
4
ＮＣ -
5
ＮＣ -
6
ＧＮＤ I
7
LED_CONT I
8
ＮＣ -
9
ＮＣ -
before using the product.
Note
Ｖ
ＬＥＤ
ＧＮＤ
LED
Open : Off GND : On
50