Communication (Command List) - Mitsubishi Electric KD Series User Manual

4-2 Communication (Command list)

4-2-2 Command list for UART communication
• Command system are different between AX/AX2 and MX series .
• <CR> means ASCII code "0x0d"
• Refer to Appendix D in this document for more information.
Function
Select Baud rate
Select Output format
Select output CLK frequency
Select Synchronization mode
LED Control
Set Dark correction
Set White correction
PGA
Set γ correction
Select resolution
Test Pattern
Software reset
Select Control mode
TM-XG537C
Command Communication format
BR
BR parameter <CR>
OC
OC parameter <CR>
OF
OF parameter <CR>
SS
SS parameter (Data) ( Data) <CR>
LC
LC parameter (Data) ( Data) <CR>
DC
DC parameter <CR>
WC
WC parameter (Data) ( Data) <CR>
PG
PG parameter (Data) ( Data) <CR>
GC
GC parameter (Data) ( Data) <CR>
RC
RC parameter <CR>
TP
TP parameter <CR>
SR
SR parameter <CR>
DT
DT parameter <CR>
COPYRIGHT © 2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
Description
Select Bard Rate (9.6kbps,19.2kbps,115.2kbps)
Select output format
Set output CLK frequency by selecting it from 17types of
them （ 48 ～ 84MHz)
Select external/internal synchronization mode
Control turning on/off of LED(illumination)
Set dark collection on/off
Set white collection on/off and collection value
Set PGA on /off and amplification degree
Set gamma correction on/off
Select output resolution from 4options.
(75/150/300/600dpi).
Optical resolution is 600dpi fixed.
Output test pattern signal.
Several test patterns are selectable.
Software Reset for ASIC/FPGA
Select from a factory setting or user settings
55