Illumination Control - Mitsubishi Electric KD Series User Manual

5-2 Setting ⑧ LED control
※ MX-NL series output the illumination emission sync. trigger signal externally

5-2-8 Illumination control

【 Input 】
Command Parameter （ DATA ） （ DATA ） CR
LC ** Upper Lower
【 Output 】
Result Parameter （ DATA ） （ DATA ） CR
** ** Upper Lower
* Illumination periods are defined by 2 byte data . Commands except for
setting Illumination period have no data.
[initial] Double side of illumination
Illumination period
[Mode]
1) Double side mode
2) A-side (single side) mode : A side is turned on
3) B-side (single side) mode : B side is turned on
Glass surface
Example
A,B both side of illumination are turned on :
LC 03 <CR> ⇒ 00 03 <CR>
TM-XG537C
CR
CR
: turn on
: 15usec
: A,B both side are turned on
Upper side (A)
Lower side (B)
COPYRIGHT © 2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
【 Illumination control 】
[Function]
Set Light-source turn on/off control and illumination
period .
For CIS with light-sources
This function be able to control built-in illumination .
For CIS without light-source(NL)
This function be able to control external illumination by
using 2 signals of the connector.
Illumination period is changeable up to 4095usec and
initial value is set 15usec at the factory .
【 Remarks 】
1) Illumination is controlled by Serial Communication of
Camera Link®. Therefore LED control does not
synchronize with line scan signal.
2) White correction data is available only for one
designated Illumination mode .
3) MX-NL CIS has illumination trigger pulse signals
adjusted by this command and these signals output a
connector. Refer the function specification .
Camera Link® is a registered trademark of AIA(Automated Imaging Association)
70