Mitsubishi Electric KD Series User Manual page 91

No. Command function
Programable Gain
8 PG
Controle
Ganmma Correction
9 GC Controle
for Output Signals
Output Resolution
10 RC
Controle
11 TP Test Pattern Output
Software Reset
12 SR
Controle
TM-XG537C
Appendix D: Command list ⑤
Code
PG 00 CR PGA function OFF : Signals are through PGA block
PG 01 CR PGA function ON
PG 20 (00) (00) CR set PGA gain Positive side
PG 21 (00) (00) CR set PGA gain Negative side
PG 80 CR Read-Out the status of PGA function
PG A0 CR Read-Out PGA gain value
Gamma Correction functio OFF : Signals are through
GC 00 CR
Gamma Correction Block
GC 01 CR Gamma Correction functio ON
GC 20 CR set 1st Threshhold value
GC 21 CR set 2nd Threshhold value
GC 22 CR set 3rd Threshhold value
GC 80 CR Read-Out the status of Gamma Correction function
GC A0 CR Read-Out 1st Threshhold value
GC A1 CR Read-Out 2nd Threshhold value
GC A2 CR Read-Out 3rd Threshhold value
RC 00 CR set 600dpi output mode
RC 01 CR set 300dpi output mode
RC 02 CR set 150dpi output mode
RC 03 CR set 75dpi output mode
RC 80 CR Read-Out Output Resolution setting
TP 00 CR Test Pattern Output OFF
TP 01 CR Test Pattern Output ON
TP 20 CR Stripe Pattern output on main scan direction
TP 21 CR Ramp pattern Output on main scan direction
TP 22 CR Read-Out the status of Test Pattern
TP 80 CR Read-Out the Test Pattern setting
TP A0 CR Read-Out the number of Test Pattern
SR 01 CR FPGA software boot start
SR 21 CR ASIC software boot start
SR 80 CR Read-Out the status of booting FPGA
SR A0 CR Read-Out the status of booting ASICs
COPYRIGHT © 2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
Detail Note
91