Table of Contents
Advertisement
5) Using a spatula, apply caulking compound (joint sealant) to all sections where
the resin may leak, such as the connections at the corners of, and the joints
between, the plastic L-angle plates, the clearances between the installation
surface and the base, etc.
Apply the tape.
Combine two plastic L-angle plates
to form the passageway.
3. Wind paper on the anchor a couple of times and fix it using the tape. Insert this
anchor into the anchor hole and perform caulking.
NOTE:
The anchor must be well caulked to prevent the epoxy resin from being
intruded into the anchor hole.
The paper wound on the anchor must be higher than the epoxy resin depth.
Epoxy resin passageway
Anchor
Paper
28
No. 2A201-519EN*A
Caulking
Hide quick links:
Advertisement
Table of Contents
