2. RAID Manager & Interface
8 Press [Esc] after selecting the drives and if a fault-tolerant RAID level (1,3 or 5)
has been selected, the controller will start parity initialization. A progress indi-
cator similar to the one shown below will be displayed. When initialization has
finished, logical drive creation is complete.
9 At this point, the logical drive has been partitioned into a single
partition covering the entire drive capacity and is inaccessible to the host.
10 If different partitioning is desired, go to "Partition Logical Drive"
(section 2.4.2.4.) menu to do the partitioning.
11 When the Logical Drive is properly partitioned, go to "View and Edit scsi id
Map" (section 2.5.) menu to map the Logical Drive Partitions to LUNs.
ASUS PCI-DA2000 Series RAID Controllers Driver Installation
Creating RAID
87 % Complete
31