Advertisement
4. NetWare Driver Installation
5 Follow the instructions in the Netware User's Manual to install the server.
6 Run the NetWare v3.11 or v3.12 SERVER.EXE program to star the server.
7 At the system console prompt, use load command to load the ASUS PCI-DA2000
Series driver by typing load DA2000.DSK[Enter]
8 System console will display the following messages on the screen:
Loading module DA2000.DSK
ASUS PCI-DA2000 Disk Driver for NetWare v3.1x
Version 1.11c November 3, 1995
Auto-loading module ASUSASPI.DSK
ASUS ASPI Manager for NetWare v3.1x, v4.0x and v4.1
Version 1.11b October 27, 1995
Supported Slot values are 11
Slot: 11
The slot number (value) is auto-detected by ASUS PCI-DA2000 Series driver
according to which PCI slot the ASUS PCI-DA2000 Series been plugged into.
Write down the slot number for later using in STARTUP.NCF.
9 At this point, press [Enter]. If ASUS PCI-DA2000 Series driver installs suc-
cessfully, the system console will display the following messages on the screen:
PCI Bus # = 0, Device # = 9, Port = E400, IRQ = 10
ASUS Disk Driver Installed Successfully
10 Load the driver "DA2000.DSK" once for each installed ASUS PCI-DA2000.
This driver supports up to four ASUS PCI-DA2000 Series Controller.
11 After each instance of the ASUS PCI-DA2000 Series driver has been loaded
successfully, continue with the operations of Novell NetWare server described
in NetWare User's Manual.
Notes:
The correct syntax in STARTUP.NCF file to load the ASUS PCI-DA2000 Series
drivers is similar to the following:
# load DA2000 slot = x
x is the slot number of slot into which the ASUS PCI-DA2000 Series been plugged.
The slot number is auto-detected by ASUS PCI-DA2000 Series driver and shown
on the system console screen during ASUS PCI-DA2000 Series driver loading.
50
ASUS PCI-DA2000 Series RAID Controllers Driver Installation
Advertisement
