Advertisement
4. NetWare Driver Installation
4.2.
Installing NetWare V4.0x/v4.1
1 Use ASUS PCI-DA2000 Series BIOS Configuration Utility to disable ISA Mail-
box Emulation mode(default is disabled). To do this, at system bootup, press
[Ctrl-I], select Configure Card option, then change IO Port Address to DIS-
ABLED.
2 Use ASUS RAID Manager or RS-232 Terminal Interface Operation to config-
ure Logical Drives and SCSI Devices and map them to valid SCSI-IDs/LUNs.
Note that SCSI ID 7 is reserved for the ASUS PCI-DA2000 Series adapter
and thus no logical drives or devices should be mapped to this SCSI ID.
3 For installation of a new server, follow these procedures:
4 If your Netware installation package is a CD-ROM version and the CD-ROM
Drive used to perform the installation is connected to an ASUS PCI-DA2000
Series, make sure the ASUS PCI-DA2000 Series ASPI manager
"I2DOSASP.SYS", CD-ROM driver "ASPICDRM.SYS", and Microsoft CD-
ROM extension program "MSCDEX.EXE" are specified in DOS files
CONFIG.SYS and AUTOEXEC.BAT.
5 Plug up to four ASUS PCI-DA2000 Series into host PCI slots then power on.
ASUS PCI-DA2000 Series BIOS will show the following messages on the screen
for each installed ASUS PCI-DA2000 Series:
ASUS PCI-DA2000 Series (PCI-TO-SCSI RAID) BIOS v1.11
PCI Bus # = 00 Device # = 0A Port = E800 IRQ = 11 EDORAM = 4MB FW=v1.12
!! Press <Ctrl><I> for Configuration Utility, <Q> to Skip !!
6 Make sure the RAID configuration is properly set. (Refer to section 4 Text
RAID Manager and RS-232 Terminal Interface Operation).
7 Change to sub-directory where the Netware install program locate, then typing
install and press Enter.
Example:
Assume the CD-ROM is mapped to DOS logical drive D, type the following at
the DOS prompt:
CD D:\NETWARE.40\ENGLISH
install
ASUS PCI-DA2000 Series RAID Controllers Driver Installation
51
Advertisement
