Advertisement
5. Windows NT Driver Installation
4 If you are installing Windows NT from a floppy drive, insert the "Windows NT
Disk #1" into floppy drive A. If you are installing Windows NT from a CD-
ROM drive, insert the "Windows NT Setup Boot Disk" into floppy drive A.
5 Power on your computer.
6 When Prompted, select Custom Setup. If you are installing Windows NT 3.1 go
to step 8.
7 Press S to skip mass storage devices detection.
8 Windows NT setup cannot find any adapter and displays NONE. Press S to
specify additional SCSI adapters. From the list of SCSI adapters, select "Other
(Requires disk provided by a hardware manufacturer)".
9 Insert ASUS PCI-DA2000 Series Distribution Diskette into floppy drive A and
press [Enter]. The screen displays "ASUS PCI-DA2000 Series PCI-TO-SCSI
RAID Miniport". Then, press [Enter] to select this driver.
10 Press [Enter] to continue Windows NT setup and follow the steps given in Win-
dows NT Installation documentation.
5.2.
Installing in an Existing NT System
If you are adding an ASUS PCI-DA2000 Series adapter to a computer that already
has an ASUS PCI-DA2000 Series adapter installed for Windows NT, then follow
step 1 through step 2 only.
If you are adding an ASUS PCI-DA2000 Series adapter to a computer that has no
ASUS PCI-DA2000 Series adapter installed for Windows NT, then follow all steps.
1 Use ASUS PCI-DA2000 Series BIOS Configuration Utility to disable ISA Mail-
box Emulation mode (default is disabled). To do this, at system bootup, press
[Ctrl-I], select Configure Card option, then change IO Port Address to DIS-
ABLED.
2 Use ASUS Text RAID Manager or RS-232 Terminal Interface Operation to con-
figure Logical Drives and SCSI Devices and map them to valid host SCSI-IDs/
LUNs. Note that SCSI ID 7 is reserved for the ASUS PCI-DA2000 Series
adapter and thus no logical drives or devices should be mapped to this SCSI
ID.
58
ASUS PCI-DA2000 Series RAID Controllers Driver Installation
Advertisement
