Advertisement
8. SCO Unix Driver Installation
8. SCO Unix Driver Installation
The chapter describes how to install SCO UNIX BTLD (Boot Time Loadable Driver)
for ASUS PCI-DA2000 Series Controller.
8.1. Installing SCO UNIX
1 Use ASUS PCI-DA2000 Series BIOS Configuration Utility to disable ISA Mail-
box Emulation mode (default is disabled). To do this, at system bootup, press
[Ctrl-I], select Configure Card option, then change IO Port Address to DIS-
ABLED.
2 Use ASUS Text RAID Manager or RS-232 Terminal Interface Operation to con-
figure Logical Drives and SCSI Devices and map them to valid SCSI-IDs/LUNs.
Note that SCSI ID 7 is reserved for the ASUS PCI-DA2000 Series controller
and thus no logical drives or devices should be mapped to this SCSI ID.
3 Check IO devices, CD-ROM or TAPE drive is properly installed.
4 Insert the N1 boot diskette into the floppy drive and turn on the PC. When the
"boot" message appears, type link as follows:
SCO UNIX System V/386
Boot: link <Enter>
5 Type PCIDA at the following prompt:
What packages do you need linked in the system,
or 'q' to quit?: pcida
ASUS PCI-DA2000 Series RAID Controllers Driver Installation
69
Advertisement
