Huawei NetCol5000-C030 User Manual page 166

NetCol5000-C(030, 032, 065) In-row Chilled Water
Smart Cooling Product
User Manual
● When pushing the display module leftwards or rightwards, pay attention to the
buckles on the panel to prevent damage to the display module.
● The gasket is used to adjust the distance between the display module and the
door panel.
● The gasket dimensions are 25 mm (L) x 12 mm (W) x 2 mm (H) and the center
aperture is 6 mm.
Step 4 Install the new display module in the original position on the front door by
performing the preceding steps in reverse order.
Step 5 Connect the control signal cables to the display module. Close and lock the front
door.
● If the main control board is not powered off, after the DP cable is inserted into
the display module, the main control board detects and initializes the display
module. This process takes 10s to 30s. Wait for 5s to 10s. The indicator on the
panel turns on, but the screen does not turn on. Wait for another 5s to 20s
until the screen is restored to the state before the replacement.
● If the main control board is powered off, power on the main control board after
the DP cable is connected to the display module. After the main control board
is powered on, the startup logo and self-check progress bar are displayed on
the display module. The home screen is displayed. The whole restoration takes
about 60s to 90s.
----End
Issue 06 (2022-12-15)
NO TICE
CA UTION
Copyright © Huawei Digital Power Technologies Co., Ltd.
7 System Operation and Maintenance
157