NEC BladeServer Express5800 Series User Manual page 205

8-12 Troubleshooting
Is the system used when Windows Server 2003 and Linux are not started?
→ Use the keyboard only when the USB floppy disk drive is not being accessed (the
access lamp is off).
– Press F6, S, and Enter in installation by using the Windows Setup Disk.
– Start of ROM-DOS Startup FD for command input
Fails to access the hard disk drive:
Refer to the documentation provided with the disk array controller for a hard disk drive in a disk
array configuration.
Is the hard disk drive compatible with the CPU blade?
→ Operation of any device that is not authorized by NEC is not guaranteed.
Is the hard disk drive properly installed?
→ Securely insert the drive carrier into the Blade Enclosure and lock it with the lever.
The hard disk drive is not connected to the internal connector when it is not
completely installed (see Chapter 3).
Inserted the correct CD-ROM but the following message is displayed:
The CD-ROM is not inserted or the wrong CD-ROM is inserted.
Is the data side of the CD-ROM dirty or damaged?
→ Take the CD-ROM out of the DVD-ROM drive, confirm that it is not dirty or
damaged, reset it, and click [OK].
Fails to access the DVD/CD-ROM:
Is the DVD/CD-ROM properly set in the DVD-ROM drive tray?
→ Take the disc out of the tray, and set the disc with its label side upward.
Is the DVD/CD-ROM compatible with the server?
→ A DVD/CD-ROM for Macintosh is not supported.
→ A disk which does not conform to the CD standard is not guaranteed to work in
the DVD drive.
Please insert the correct CD-ROM.
OK