NEC BladeServer Express5800 Series User Manual page 265

Installation of Windows Server 2003 R2 x64 Editions
Install Windows Server 2003 R2 x64 Editions in the following procedure:
1.
Insert the Windows Server 2003 R2 x64 Edition CD-ROM into the DVD-ROM drive.
2.
Turn on the CPU blade.
3.
Press F6 when the message "Setup is inspecting your computer's hardware
configuration..." appears at the top of the screen.
NOTE:
Use the keyboard only when the USB floppy disk drive is not being
accessed (the access lamp is off).
The following steps are not required if F6 is not pressed.
Refer to the "First Step Guide" for details.
4.
When the following message appears, press S:
Setup could not determine the type of one or more mass storage
devices installed in your system, or you have chosen to
manually specify an adapter. Currently, Setup will load
support for the following mass storage devices.
The following message appears:
Please insert the disk labeled
manufacturer-supplied hardware support disk
into Drive A:
* Press ENTER when ready.
5.
Insert the Windows Server 2003 x64 Edition OEM-DISK for NEC EXPRESSBUILDER
into the floppy disk drive and press Enter.
A list of the drivers for the mass storage devices is displayed.
6.
Select [LSI Logic MegaRAID SAS RAID Controller Driver (Server 2003 for x64)] and
press Enter.
If a message appears, press S.
Then, it returns to the screen of Step 4.
7.
If an optional device is installed, select the proper driver and press Enter.
– Emulex LPX000 PCI Fibre Channel HBA
(When Fibre Channel controller (N8403-018) is used..
8.
When the following message is shown, press Enter to start "Welcome to Setup."
Installing the Operating System B-7