NEC BladeServer Express5800 Series User Manual page 245

6.
From the top of the CPU unit, position the connector of the mezzanine card so that it
aligns with the connector of the mezzanine card slot, and insert the mezzanine card into
the slot.
IMPORTANT:
Do not touch the terminals on the board. A contact failure may occur
if the board is installed with dirt and oil adhering to the terminals.
Insert the mezzanine card straight into the connector. The terminal
or connector may be damaged if it is not inserted correctly.
If the board cannot be installed securely, remove the board and then
install it again. Applying excess force to the board may damage it.
7.
Push the mezzanine card firmly to connect the card to the slot.
8.
Tighten the screws to secure the mezzanine card to the spacer on the CPU blade.
9.
Replace the top cover.
10.
Secure the top cover with the two screws.
11.
Install the CPU blade in the Blade Enclosure according to the User's Guide of the Blade
Enclosure.
12.
Power on the CPU blade. Make sure that no error messages associated with the card
appear on the POST screen.
See Chapter 8 for details of POST error messages.
13.
In the BIOS Setup utility, set [Advanced] – [Reset Configuration Data] to [Yes].
This is required to update the hardware update information. See Chapter 4 for details.
14.
Run the BIOS configuration utility of the mezzanine card to configure it.
The BIOS configuration utility may vary depending on the type of the mezzanine card.
Refer to the documentation provided with the card for details.
Type I
Upgrading Your Server 9-21
Type II