NEC BladeServer Express5800 Series User Manual page 252

9-28 Upgrading Your Server
Removal (Storage Unit)
To remove the mezzanine card, follow the procedure below:
1.
Shutdown the CPU blade and turn off the power.
2.
Remove the CPU blade from the Blade Enclosure.
Refer to the User's Guide of the Blade Enclosure.
3.
Place the CPU blade on an anti-static sheet.
4.
Remove the two screws securing the top cover.
5.
Firmly hold the cover, move it slightly toward the rear of the CPU blade, and then lift the
cover to remove it.
6.
Remove the cables from the connectors for signal cable (2)-A and (2)-B on the CPU unit
and the storage unit.
IMPORTANT:
cable to remove it.
7.
Remove the two screws securing the bracket.
8.
Remove the bracket.
9.
Remove the cable from the connector for signal cable (1).
10.
Remove the four screws from the CPU unit tray.
11.
Firmly hold the CPU unit, move it slightly toward the rear of the CPU blade, and then lift
the CPU unit to remove it.
IMPORTANT:
12.
Remove the three screws securing the mezzanine card.
13.
Hold both ends of the mezzanine card and remove it from the slot.
Lift the card straight up from the storage unit.
Push the unlock button of the connector, and lift the
Pay attention to the cable removed in Step 9.
Type I
Type II