Huawei NetCol5000-A050 User Manual page 132

NetCol5000-A050 In-row Air Cooled Smart Cooling
Product
User Manual (1350 mm Depth)
Figure 6-10 Teamwork Settings
Parameter
Teamwork group num
System address
Enable teamwork
CAN resistor
Teamwork function
Networking mode
Teamwork parameter
synchronization
Number of systems in
this group
Issue 04 (2022-12-15)
Description
Specifies the planned teamwork group number. This
parameter should be the same for all units in the same
teamwork group.
Specifies the planned unit address. The addresses of
units in the same teamwork group must be unique.
If CAN network is selected, set Enable teamwork
CAN resistor to Yes for the first and last units. If
Enable teamwork CAN resistor is set to No for the
first and last units, the CAN communication quality will
be affected, and even the teamwork CAN networking
will fail.
Yes: The teamwork control CAN resistor is enabled for
the unit.
No: The teamwork control CAN resistor is disabled for
the unit.
Specifies whether to enable the teamwork function. Set
this parameter based on onsite heat load distribution.
● Disable: A unit operates independently.
● Enable: A unit operates in team with other units.
Specifies the networking mode for teamwork control.
The networking mode selected on the screen must
match the actual networking mode. Otherwise, the
teamwork function is unavailable.
If Teamwork function and Teamwork parameter
synchronization are both set to Enable, you can select
Set Local or Set Teamwork when setting parameters.
NOTE
Specifies the total number of units in this group. The
value is an integer ranging from 1 to 32.
NOTE
Copyright © Huawei Digital Power Technologies Co., Ltd.
● Set Local: Set parameters for the local unit.
● Set Teamwork: Set parameters for all units in a teamwork
group.
This parameter is displayed after Teamwork function is set to
Enable.
6 Power-On Commissioning
122