Panasonic VB-44210G User Manual page 207

Section 700 - Operation
5. Press ON/OFF again.
Related Programming
• FF10 (Speed Dialing): Personal Speed Dial Numbers
• FF3 (Extensions): PSD Name Display (5 or 10 Names)
• FF6 (Name): PSD Names
Considerations
• Personal Speed Dial numbers can contain up to sixteen characters,
• A dash ("-") can be displayed in the Personal Speed Dialing number. To
• A flash may be entered by pressing the FLASH key.
• If you make a mistake while programming, an alarm tone is issued and
• Storing a new number erases any previously stored data.
• Names for Personal Speed Dialing can be programmed using a DSS
• If the called party's number and name are stored in the Personal Speed
• Speed Dial numbers cannot be checked while Station Lockout is activated.
• With CPC-AII and CPC-B Version 7.0 and higher, if the Speed Dial is
DBS-2.3/9.2-700
including the "*," "#," "-", FLASH, PAUSE (REDIAL), CONF, and
AUTO keys.
display a dash, press the FF6 key where you want the dash to appear. The
dash will not appear during programming but will appear when the number
is dialed or checked.
"ERROR" appears on the display. If this happens, start again from step 1.
console at the Attendant Phone.
Dial code, that information appears on the display when you use the speed
dial code.
used to forward to an outside number and Least Cost Routing is enabled,
the Speed Dial cannot use Trunk Access "9." Use trunk access 81-86
instead.
DBS Manual - Revised April 2000
Chapter 4. Key Telephone Features
4-91