Table of Contents
Advertisement
Chapter 3. System Features
2. Dial "#521." (Note: #520 can be used to toggle between modes.)
3. Press the ON/OFF key.
Related Programming
• FF1 (System): Ring Patterns for UNA Terminals (M, C, & B)
• FF4 (Ringing and Hunt Groups): CO Day Ring Assignments
• FF4 (Ringing and Hunt Groups): CO Night Ring Assignments
• FF4 (Ringing and Hunt Groups): CO Night2 Ring Assignments
Hardware Requirements
• Calls during a Night Mode are often indicated by external paging speakers
Considerations
• Day, Night and Night 2 modes can be assigned to FF keys on an attendant
• If the same mode key is assigned on different attendant positions, each key
• If the system is programmed to switch between night and day modes
Page 3-38
• The ON/OFF LED lights.
• The ON/OFF LED goes off.
• "DAY MODE" appears on the display.
or an external ringing device, such as a night bell. External paging and
ringing devices are not provided with the DBS; they must be purchased
separately.
phone. The attendant can switch between Day, Night and Night 2 modes
simply by pressing the appropriate key. The FF key lights red when the
system is in the assigned mode. Alternatively a DAY/NIGHT1/NIGHT2
toggle mode key can be assigned. Pressing the key toggles between modes.
When in Day mode, the FF key LED is not lit. When in NIGHT1 mode, the
LED lights red. When in NIGHT2 mode, the LED lights green.
indicates the current mode. For instance, if a NIGHT1 key is assigned for
two attendants, both light when in NIGHT1 mode.
automatically, you can manually switch between modes by using the
"#520/#521/#522/#523." (This is different than earlier versions of
software.)
DBS Manual - Revised April 2000
Section 700 - Operation
DBS-2.3/9.2-700
Hide quick links:
Advertisement
Table of Contents
