Table of Contents
Advertisement
2.2
Com Loop Units
Addressable COM loop units are connected directly to a COM loop.
2.3
Address and Mode
The addressable units must have both address and mode set. This is done in different ways
for different units, for example address setting tool 4414E, DIP switches, jumpers, or via
the FDCIE display. For more information, please refer to the Technical Description of each
unit respectively.
2.4
Software (S/W) Versions
Due to continual development and improvement, different S/W versions may be found.
When installing a new Control Unit in a system with "older S/W" Control Units, you must
upgrade the S/W in the old Control Units with the current S/W or downgrade the new
Control Unit software by downloading the same older S/W version in the new Control Unit.
The same S/W version is required in all Control Units in a TLON Network
2.4.1
EBLWin
The PC program EBLWin is used for programming and commissioning of one or more
Control Units.
EBLWin Key 5094 is a USB dongle that has to be plugged in the PC in order to log on to
the FDCIE.
2.4.2
TLON Manager
TLON Manager is an installation and maintenance tool used for the TLON Network
programming and setup, it is Windows based PC software.
2.5
Applications
The FT1020G3 system is intended for small, medium and large installations. The intelligent
Control Units offer the system designer and end user a technically sophisticated range of
facilities and functions.
Programming with the PC programs EBLWin and TLON Manager and commissioning of
the Control Unit / system is an easy process. Start with one Control Unit and then, when
required, add more units. The TLON network allows the installer to install the Control Units
in one building or in different buildings.
14
Operation Manual
FT1020G3 Rev 2.10.4
Advertisement
Table of Contents
