Table of Contents
Advertisement
User Data & Access Levels
6
6.1
User Data
FT1020G3 supports different levels for different users. To log on to an FT1020G3, a User
name and Password are required. Ten different User names with individual Passwords
can be used.
Via EBLWin (menu "System"), ten different User names with individual Passwords can be
defined in the "User data" dialog box. One of three different levels / types can be selected
for each user name. User name must be used to log on to an FT1020G3 and/or for Web-
server access.
The default user names and passwords are shown below:
Note 1: The default user names and passwords can be changed in EBLWin. Also, the Fire
alarm access and WEB-server access columns have to be filled in (check boxes),
depending on how the user names and passwords should be used.
Note 2: In a new FDCIE. (i.e. before downloading any Site Specific Data), only user "0" is
available. No password is required and you have access to all menus. After download of
SSD the downloaded user names and passwords will be valid.
6.1.1
User Name
Up to ten users, 0 to 9, may be programmed. By default, three users are available:
0 = Information only
•
1 = Building officer
•
•
2 = Service personnel
6.1.2
Password
Each user has a password for an access level e.g. "Information only", "Building officer" or
"Service personnel".
Change of Password
Normally the user names and passwords are downloaded / changed via EBLWin and SSD
download. A logged-on person (user name) can also change his/her password via menu
H10.
If the valid password(s) are unknown, another EBLWin download must be performed to
change the password(s).
CHANGE VIA MENU H10, See 31, page 168.
Note: Brooks recommend a copy of the SSD to be given to the building manager. If the
password has changed, it can't be restored, new SSD must download to the FDCIE.
41
Operation Manual
FT1020G3 Rev 2.10.4
Advertisement
Table of Contents
