Set base station mode
Set base station ------- to Register
" |"
Set base station mode
Set base station ------- to Register
"↲ "
"ESC".
A8 Setup wireless detector
Note: The base station must be set back to the "Normal state" for the wireless detectors to
function normally.
Unregister
Install
-- Base station mode (1) -------------------------------------------
Register, base station 000001
Unregister
Install
144
Operation Manual
FT1020G3 Rev 2.10.4
Select a Base station in the
list and press "↲ " to go
from Register mode back to
Normal state. The Base
station will disappear from
the list, indicated with a
beep.
The same procedure is
valid for the Unregister and
Install modes.
Press "ESC" to go back
to menu "A8".
Scroll to another menu or
press "ESC".