Table of Contents
Advertisement
■
Model with touch panel
Error Message
Upper line
Access
Function Locked.
Denied
Function Locked.
Job Deleted.
Access Error Press Stop.Put the
device back in and
try again.
Calibration failed.
Calibration
Insufficient Toner
for Calibration.
Calibration failed.
Press [Retry], and
try again.
Calibration failed.
Turn the power off
and then back on
Cartridge
Put the Black (BK)
Toner Cartridge
Error
back in.
Put the Cyan (C)
Toner Cartridge
back in.
Put the Magenta
(M) Toner
Cartridge back in.
Put the Yellow (Y)
Toner Cartridge
back in.
Condensation Leave switched
ON. Fully open the
front cover. Wait
Cooling
Wait for a while
Down
Middle line
In the case of PC-print,
authentication of print restricted
ID failed.
The device was removed during
data was being processed.
Dot counter or develop roller
counter of color toner has
reached the upper limit during
color density adjustment
performed from the control panel.
Density patch measurement
ended unsuccessfully during
color density adjustment
performed from the control panel.
Error occurred with the value
measured during density sensor
sensitivity calibration.
Error occurred with the value
measured during color density
adjustment performed from the
control panel.
The new toner sensor of the
toner cartridge (Black) could not
detect a new cartridge properly.
The new toner sensor of the
toner cartridge (Cyan) could not
detect a new cartridge properly.
The new toner sensor of the
toner cartridge (Magenta) could
not detect a new cartridge
properly.
The new toner sensor of the
toner cartridge (Yellow) could not
detect a new cartridge properly.
Condensation occurred in the
machine.
The internal temperature sensor
or side thermistor of the fuser unit
detected a temperature higher
than the specified value.
2-31
Error
State
Codes
9802
9803
9804
9801
4F01
4F04
4F03
4F02
1400
6801
Refer
to:
---
4.10.3
---
4.10.3
---
4.11.2
2-76
2-77
2-77
2-76
2-53
2-53
2-53
2-53
2-48
2-59
Confidential
Advertisement
Table of Contents
Troubleshooting
