Brother HL-L9300CDW Service Manual page 56

Error Message
Upper line
No Tray T2 -
No Tray T3 -
Install the Waste
No Waste
Toner Box.
Toner
Out of Press Stop [x].
Memory
Print Data Secure Print Data
Full is full. Press Stop
[x] and delete the
previously stored
data.
Prinit Unable Turn the power off
** and then back on
again.
Registration failed.
Registration
Insufficient Toner
for Registration.
Registration failed.
Press [Retry], and
try again.
Registration failed.
Turn the power off
and then back on
again.
Middle line
The T2 paper feed sensor
detected that the T2 paper tray
unit is open in printing by feeding
paper from the T3 paper tray unit.
(after the registration of printing in
the engine)
The T2 paper feed sensor
detected that the T2 paper tray
unit is open in printing by feeding
paper from the T3 paper tray unit.
(before the registration of printing
in the engine)
While the T3 paper tray unit is
open state, print or adjustment
operation was attempted.
The waste toner sensor detected
that no waste toner box was set.
The memory is insufficient to
expand the data of PC-Print.
The memory used to store
secure print data exceeded the
memory size for secure print
data.
Error related to print
Refer to the error code of "**".
Dot counter or develop roller
counter of color toner has
reached the upper limit during
auto color registration performed
from the control panel.
Error occurred during patch data
printing in auto color registration
performed from the control panel.
Error occurred with the value
measured during auto color
registration performed from the
control panel.
2-36
Error
State
Codes
8506
8502
8403
6300
C700
C800
9A02
9A03
9A01
Refer
to:
2-68
2-68
2-67
2-58
2-81
2-81
**
2-78
2-79
2-78
Confidential