Table of Contents
Advertisement
Error Message
Upper line
Take out Tray 2 and
Tray 2 Error
push it back in
firmly.
Take out Tray 3 and
Tray 3 Error
push it back in
firmly.
Press Stop[x].Wait
Unable to
until Ready state
Update
and try again.
Unusable Device
Unusable
Device
Remove the
Device. Turn the
power off and back
on again.
-
2-sided
Disabled
Reload paper,
then press [Retry].
Middle line
After the T2 paper tray unit is
opened and closed or the power
is turned ON, the T2 plate origin
sensor detects that lift-up of the
plate of the T2 paper tray unit is
not completed within the
specified period of time.
After the T3 paper tray unit is
opened and closed or the power
is turned ON, the T3 plate origin
sensor detects that lift-up of the
plate of the T3 paper tray unit is
not completed within the
specified period of time.
Execution of the program update
cannot be started because other
function is being executed.
An USB device that did not meet
the specifications was inserted
into the USB port.
Overcurrent was caused
because a USB device that did
not meet the specifications was
inserted into the USB port.
The back cover sensor detected
the open state when
2-sided printing is started.
(before the registration of printing
in the engine)
The back cover sensor detected
the open state during 2-sided
printing. (after the registration of
printing in the engine)
The registration rear sensor
detected that the length of the
paper is too long and it may hit
within the machine in 2-sided
printing.
2-40
Error
State
Codes
6C02
6C03
EC00
8903
8904
8A02
Refer
to:
2-60
2-61
---
4.11.3
---
4.11.2
2-83
2-69
2-69
2-69
Confidential
Advertisement
Table of Contents
Troubleshooting
