[Yes]: The same display appears as when you
execute the "Save as" command.
Save as}
If you select "Cancel", KPG-71D ends and
the current configuration data is not saved.
[No]: The operation of KPG-71D ends and the
configuration data will not be saved.
[Cancel]: This option allows you to abort without
quitting the program.
4.2.3.2. Model
Select a protocol for communications between
KPG-71D and the KDS-100. A pull-down menu
appears when selecting the command from the
Menu.
Model Information
The following window appears when selecting "Model
Information" at the [Model] command.
Select a protocol to perform data transmission in this
window. There are two protocols; select the protocol that
suits your transceiver.
FleetSync (DMS) PC: Use this protocol if the
transceiver supports FleetSync: TK-780, TK-880,
TK-980, TK-981 series, etc.
FleetSync (DMS) AIR: Use this protocol if the
transceiver does not support FleetSync: TK-760G,
TK-860G, TK-762G, TK-862G, series etc. These
transceivers modulate radio frequency to support
FleetSync data.
Select an appropriate protocol and click [OK]. Click
[Cancel] to close the window without configuring the
protocol.
4.2.3.3. Edit
Configure the data that constructs the operating
environment of the KDS-100. The pull-down menu
appears when selecting the command from the
Menu.
Optional Features
This command allows you to adjust the configuration
that relates to the KDS-100 operation. The following
window appears when executing the command from the
Menu.
{Refer to 4.2.3.1.
There are five tabs on the top of the window: Display,
Key, Tone, Radio, and Others. You can switch the
window by clicking these tabs to go to each
configuration display.
{Refer to 4.2.3.3. Display} {Refer
to 4.2.3.3. Key} {Refer to 4.2.3.3. Tone} {Refer to
4.2.3.3. Radio} {Refer to 4.2.3.3. Others}
T T T T Tab descriptions
z Display
This tab allows you to configure the KDS-100 display.
・ Power ON Message
You can configure the setup display of the KDS-100
here.
{Refer to 3.2.1.}
・ List
The setup screen can be set to Off, Text, or Bitmap.
OFF: The setup screen will not appear.
Text: A text message appears on the setup screen.
Bitmap: A picture appears on the setup screen.
・ Duration
You can configure the display duration of the setup
screen. You can set the duration from 1 to 10 seconds,
in steps of 1 second, by pressing the ∧ ∧ ∧ ∧ and ∨ ∨ ∨ ∨ keys on
the right of display. You can also directly enter a value,
but you cannot enter a decimal value or a number
larger than 10.
"Continuous" may appear when clicking buttons. The
sound keeps beeping when you have selected
"Continuous". Press the function key [1] to go to each
mode display. Enter 0 to set the display duration to
"Continuous"
4. KDS-100 Configuration
21