Quick Status Response Keys; Status List 1; Status List 2 - Kenwood KDS-100 Technical Document

・
De-bounce time
Configure the de-bounce time.
Setting the de-bounce time will insure the proper
and complete closure of relay contacts before
acting on it's open or closed state.
You can set the duration from 0.1 to 5.0 seconds,
in steps of 0.1 second, by pressing the ∧ ∧ ∧ ∧ and ∨ ∨ ∨ ∨
keys on the right of the display. You can enter the
value directly, but you cannot enter two decimal
places or a number that is out of range.
z Quick Status Response Keys
This tab allows you to configure the Status call
displayed on the message receipt display. The
following window appears when clicking the tab.
Five input windows are used to assign Status calls
to the function keys on the message receipt
display. {Refer to 3.3.1.2.} Each input window
assigns a Status call to function keys [1] – [5].
The Status call, which is entered into the left side
diagram, is displayed in the Status call list by
clicking the input windows. Select the desired
status call from the message receipt display list.
The selected Status call is assigned to the function
key on the message receipt display.
If you leave the windows blank or select "NONE",
the status call is not assigned to any function keys
and you cannot make a Status call from the
message receipt display. The function key will not
be displayed.
The first seven characters of the KDS-100 appear
on the display. The following characters will not be
displayed.
4. KDS-100 Configuration
z Status List 1
This tab allows you to configure the Status call
displayed on the Status List display. The following
window appears when clicking the tab.
Five input windows are used to assign Status calls
to the function keys on the Status List 1 display.
{Refer to 3.3.2.4. Display description}
window assigns a status call to function keys [1] –
[5]. The Status call, which is entered into the left
side list, is displayed in the Status call list by
clicking the input windows. Select the desired
Status call from the Status List 1 display list. The
selected Status call is assigned to the function key
on the Status List 1 display.
If you leave the windows blank or select "NONE",
the Status call is not assigned to the any function
keys and the Status List 1 display will not appear.
The first seven characters of KDS-100 appear on
the display. The following characters will not be
displayed.
z Status List 2
This tab allows you to configure the Status call
displayed on the Status List display. The following
window appears when clicking the tab.
Five input windows are used to assign Status calls
to the function keys on the Status List 2 display.
{Refer to 3.3.2.4. Display description}
window assigns a Status call to function keys [1] –
[5]. The Status call, which is entered into the left
side list, is displayed in Status call list by clicking
the input windows. Select the desired Status call
from the Status List 2 display list. The selected
Status call is assigned to the function key on the
Status List 2 display.
Each input
Each input
31