Huawei NetCol5000-A050 User Manual page 244

NetCol5000-A050 In-row Air Cooled Smart Cooling
Product
User Manual
● Do not frequently or quickly disconnect and connect the DP cable of the display
module. Do not forcibly pull the DP cable.
● You are advised to power off the main control board (or main control module)
before replacing the display module.
● If the main control board is not powered off, you are advised to back up the
configuration file of the product by referring to
1.
2.
3.
4.
5.
Issue 13 (2023-08-20)
CA UTION
Open the front door and do not damage the cables connected to the display
module.
Remove the cables from the display module.
Use a Phillips insulated torque screwdriver to remove the four screws and
gaskets that secure the display module, and pull out the display module.
NO TICE
– When pushing the display module leftwards or rightwards, pay attention to
the buckles on the panel to prevent damage to the display module.
– The gasket is used to adjust the distance between the display module and
the door panel.
– The gasket dimensions are 25 mm (L) x 12 mm (W) x 2 mm (H) and the
center aperture is 6 mm.
Figure 11-41 Replacing a display module
Install the new display module in the original position on the front door by
performing the preceding steps in reverse order.
Connect the control signal cables to the display module. Close and lock the
front door.
Copyright © Huawei Digital Power Technologies Co., Ltd.
11 Parts Replacement
a or b.
233