Diagnostics; What Is Available; Before You Start - NEC UNIVERGE SV9100 System Maintenance Manual

Issue 1.0

Diagnostics

W
S 1
ECTION
The SV9100 has a Diagnostic Interface Module (DIM) built into the
GCD-CP10 (CPU) blade. The DIM can monitor the activity of the system under the control of commands
entered by the engineer. The DIM is accessed via the Ethernet interface of the GCD-CP10 blade.
B
S 2
EFORE YOU
ECTION
As well as monitoring the system, the DIM can also be used to change the operation of the system.
For this reason DO NOT enter the following commands, as they will cause a system restart:
Some DIM commands give a real time output when the command is entered, others will give an output until
you enter the command that turns it off. You can turn on multiple DIM outputs by entering relevant
commands one after the other.
The SV9100 will continue to operate normally with the DIM is running.
22
A
HAT IS VAILABLE
S
TART
RESET
o
RESTART
o
SHUTDOWN
o
or any other command that looks like a reset request.
o
?
UNIVERGE SV9100
System Maintenance
Chapter
3