NEC UNIVERGE SV9100 System Maintenance Manual page 54

Issue 1.0
42
Enter Function
IP GW Displays the SV9100 Default
Gateway (PRG10-12-03)
IP ARP Displays the SV9100 ARP
(Address Resolution Protocol)
cache. This is a table of MAC
address to IP Address
mappings.
IP ROUTE Displays the SV9100 routing
table. Usually this will consist
of just a few entries, as the
default gateway is used for
any traffic destined for a
different IP subnet.
IP DSP INFO This shows how many DSP
channels are in use at a
particular moment in time.
IP DSP INFO 1 This shows how many DSP
channels are in use at a
particular moment in time for
all device types.
Ping <ip address> The commonly used "ping"
utility has been implemented
on the GCD-CP10. This is a
very useful fault finding tool.
UNIVERGE SV9100
DIM Output
[ Default Gateway ] : 192.168.1.254
See below
See below
See below.
See below.
VoIPU >ping 192.168.11.200
Pinging 192.168.11.200 with 32 bytes of
data:
Reply from 192.168.11.200:
Reply from 192.168.11.200:
Reply from 192.168.11.200:
Reply from 192.168.11.200: Ping statics
for 192.168.11.200:
Packets: Sent = 4, Received = 4, Lost = 0
(0% loss):
System Maintenance Manual