Logging Operation Setting - Mitsubishi Electric MELSEC iQ-R Series User Manual

Logging operation setting

Set the settings related to the logging operation of high speed data logger modules.
Window
Click "Common setting" on the edit items tree, then click the [Logging operation setting] button.
Displayed items
Item
Enable the auto logging function
Conditions for stopping
the operation of module
Specify the waiting time for the module operation start
• By exporting setting in which auto logging function is enabled, to the SD memory card, logging can be
started without updating settings when the SD memory card is replaced.
• CARD RDY LED turns OFF when the module operation stops and the SD memory card is ready to be
removed.
• When "Stop effected by a timer" is specified, specify the elapsed time more than five seconds longer than
the period of logging time. When module operation stops, unprocessed data are not logged. (Page 318
Number of saved files exceeded information (Un\G2016 to 2019))
• When starting high speed data logger module (powering ON or resetting a CPU module) without inserting
an SD memory card to use the auto logging function, pay attention to the following:
Do not connect high speed data logger module to LAN.
Do not set to transfer files and send e-mails in the data logging setting, event logging setting, and report
setting.
High speed data logger module operates with the default IP address (192.168.3.3).
• When connecting Configuration Tool with the auto logging function, follow the descriptions in 'System
configuration when performing initial setup, maintenance, and inspection'.
(MELSEC iQ-R High Speed Data Logger Module User's Manual (Startup))
2 HIGH SPEED DATA LOGGER MODULE CONFIGURATION TOOL
144
2.4 Common Setting
Stop due to the maximum
number of saved files over
[Change all settings to stop]
button
Stop by a timer
Description
Select this to use the auto logging function.
Select the stop condition to stop the module operation when the maximum number of data logging,
event logging, or report saved files is exceeded.
Changes the "Operation occurring when number of saved files is exceeded" to "Stop" in all the
data logging settings, event logging settings, and report settings.
Select this to stop module operation when the set time elapses after module operation starts.
Specify the amount of time until the module stops.
Select this when waiting a certain period of time until the module operation starts after powering
ON. Specify the waiting time that was required until the operation starts.