High speed sampling failure (X1A)
This signal turns ON when high speed sampling failure occurs in data logging, event logging or report. (Page 344
Processing Time)
This signal turns OFF by updating the settings.
Processing overload occurrence (X1B)
This signal turns ON when a processing overload occurs in data logging, event logging or report. (Page 344 Processing
Time)
This signal turns OFF by updating the settings.
Trigger reoccurrence (X1C)
This signal turns ON when trigger reoccurs in data logging. (Page 344 Processing Time)
This signal turns OFF by updating the settings.
Creation trigger reoccurrence (X1D)
This signal turns ON when trigger reoccurs in report. (Page 344 Processing Time)
This signal turns OFF by updating the settings.
General sampling delay occurrence (X1E)
This signal turns ON when a general sampling delay occurs in data logging, event logging, or report. (Page 344
Processing Time)
This signal turns OFF by any of the following operations.
• Updating the settings
• Setting a value more than the general sampling delay time (maximum) in the 'allowed general sampling delay time'
(Un\G804 to 805).
APPX
Appendix 2 Input/Output Signals
A
297