Panasonic KX-T336 System Reference Manual page 212

(2) What if a call rinoina at overflow destination
/AlT/EXT.) is not answered?
Overfbw destination (ATT/EXT.)
I
(No answer)
(A) A call which comes in directly on the overflow
destination*' continues to ring on it.
(B) A call which comes in on the overflow
destination after being answered or held
once by the system'2 will be disconnected
automatically, if not answered by the overflow
destination within 60 seconds.
l
' A call via DIL 1 :l , DID.
l
2 A call via DISA, transferred by ATT or
Extension, or a call held by the system as a
treatment of the UCD Time Table.
6.
OGMl
and OGM2
To utilize OGM, install Direct Inward System
Access (DISA) card to the system and assign
the usage of DISA card to ffiM1 and/or
OGM2 by system programming in advance.
The Operator 1 can record OGM.
Up to four DISA cards can be installed to the
system.
Four OGMs per DISA card can be sent to
outside callers simultaneously.
Refer to Section 3-F-4.00,4-l-l 3.00 and
6-J-6.00 "Outgoing Message (OGM)
Recording and Playing Back," tor further
information.
7. UCD TImetable
When all extensions in a UCD group are busy,
calls are handled according to the pre-
programmed timetable.
The timetable is assigned to the system by
employing "UCD Time Table-UCD (2Q)" in
system programming.
(1) Number of timetables
Each UCD group (01 to 04) has own timetable
respectively.
(2) Up to 16 steps can be registered par timetable
by selecting a command listed below.
Command list and functions
Command Functions
1T Callers are put in the waiting queue
for 15 seconds.
2T Callers are put in the waiting queue
for 30 seconds.
3T
Callers are put in the waiting queue
for 45 seconds.
4T Callers are put in the waiting queue
for 60 seconds.
OlW
When OGMl is in use, wait until
OGMl becomes available and then
OGMl is sent to the caller.
02w
When OGM2 is in use, wait until
OGM2 becomes available and then
OGM2 is sent to the caller.
01s OGMl is sent to the caller if
available.
02s
H
TR
OFF
When OGMl is in use, skips to the
next step without sending OGMl .
OGM2 is sent to the caller if
available.
When OGM2 is in use, skips to the
next step without sending OGM2.
Music-on-Hold is sent to the caller.
Transfers a call to the overflow
destination set by "OFDN" of
"Special Attended-UCD( l/2)" in
system programming.
Disconnects the outside call.
Note: Any command after "TR" or "OFF" does not
function.
3-D-13
(40993)