Message Waiting; 4-L-L - Panasonic KX-T336 System Reference Manual

8.00 Message Waiting
Description
Allows an extension user to indicate to another
exiensmn that a message is waiting for him or her,
by
turning on the MESSAGE indicator (button) on
the
called extension.
The extension user who received the message
waiting indication can call back the message
sender by simply going off-hook and pressing the
red lit MESSAGE indicator (button).
This feature is useful when the calied extension is
busy or does not answer the call.
Up to 500 message waiting indications can be set
for the whole system.
Programming
System Programming
"System-Tenant' ,
Message Waiting Boundary
"System-Numbering
Plan (7/9)".
Message Cancel
"Extension-Station (Z/3)".
DN Key Type
"Extension-Station (3/3)-,
DSS Key
Type
Conditions
1. Suitable Telephones:
(1) Message Sender _
(1) Receiver' s extension is:
l
A
PITS telephone without a MESSAGE
button.
l
A Single Line Telephone without
MESSAGE lamp.
(2) The maximum number of message wafting
indications available for the system or
tenant l/2 has been assigned.
If your PITS has a display, it shows:
MW Not Accepted
3. Tenant Service
The maximum number of message waiting
indications available for Tenant
1
and 2 is
determined by "System-Tenant" Message
Waiting Boundary.
4. Setting of the multiple message waiting
indications
(1) More than one message sender can leave
message waiting indications to the same
extension at the same time.
(2) Even if the same message sender sets
message waiting indications to the same
extension more than once, this leaves only
one message on the called extension.
.-
5. The MESSAGE indicator on the message
receiver' s extension will be turned off when:
- .Anendant Conso@%
' " .' i
' a;
l
A PITS telephone with a MESSAGE
(1) The message receiver c% back the
button.'
message sender by pressing the red lit
l
Any Single Line Telephone
MESSAGE button, and it was answered by
(2)
Message Receiver
l
A PITS telephone with a MESSAGE
the message sender (or by another
extension using Call Pickup or an SDN
button).
l
1
button:
l
A Single Line Telephone with
MESSAGE lamp.
* Refer to <Supplement> on page
4-l-17 for
further information.
(2) Message waiting indication is canceled by
the message sender.
l
'
(3) Message waiting indications are canceled
by the message receiver.' *
2. Reorder Tone
A caller who attempts to leave message waiting
l
' The indicator may not be turned off, if there are
other message waiting indications sent by other
extensions.
indication may hear the reorder tone in the
following cases:
l
7 All message waiting indications are canceled at
once.
4-l-l
5
(30393)